Expert Answers about Fleetwood Pace Arrow Motorhome

• Installing Replacement Landing Gear on 1993 Avion 35 Gooseneck
• Great question. Almost all landing gear includes both bolting and welding. The brackets are welded to the trailer and then the legs have weld stops where the brackets fit and are bolted into place. Most landing gear is fairly similar in the weld stop locations, so new legs don't normally require replacing the brackets however there are some that require cutting off the old brackets and welding new ones in place. For instance the Lippert Electric Landing Gear Set - Weld On - 37" Lift...
  view full answer...


• Can MORryde Power Cord Storage System be Used on Hardwired
• If you wanted to use a Power Cord Storage system like the part # MR77RR on a hardwired setup you'd have to use it a little differently and it may not be as convenient. You'd have to put the end of the cable in the reel and then roll up it up "backwards" basically from there. So to use it you'd have to unroll it completely off the reel and then grab the end of the cable and take it where it needs to go.
  view full answer...


• How to Wire Up Replacement 3-Speed Switch for Fan-Tastic Vent Roof Vent FVK1031-05
• You can trace the connectors you have on your fan assembly to determine where they terminate in order to install the new switch # FVK1031-05. Why your old switch had only 2 of them connected I can't say unless it did not have all the functions that this switch controls. If looking at the back of the switch the single terminal on the left next to the spring is the power terminal. On the right side the upper terminal goes to the circuit board. And the lower right terminal goes to the fan...
  view full answer...